TM 9-2350-256-20-1
0092 00
CORRECTIVE ACTION Continued
12. Reconnect driver's vehicle exhaust smoke bracket to bulkhead connection wiring harness to driver's
switch plate disconnect. Open air inlet doors (TM 9-2350-256-10). Disconnect bulkhead to engine
bracket and rear fuel tank transmitter wiring harness from bulkhead disconnect. Place red lead of
multimeter in socket C of wire T and black lead to ground. Turn MASTER and driver's VEHICLE
EXHAUST SMOKE switches ON and check for voltage. Turn MASTER and driver's VEHICLE
EXHAUST SMOKE switches OFF. If voltage is present, go to step 13. If voltage is not present,
repair/replace wire T of driver's vehicle exhaust smoke bracket to bulkhead connection wiring harness
(see WP 0242 00).
13. Reconnect bulkhead to engine bracket and rear fuel tank transmitter wiring harness to bulkhead.
Remove engine deck (see WP 0336 00). Disconnect smoke generating system lead assembly from
engine connector. Place red lead of multimeter on wire T and black lead to ground. Turn MASTER
and driver's VEHICLE EXHAUST SMOKE switches ON and check for voltage. Turn MASTER and
VEHICLE EXHAUST SMOKE switches OFF. If voltage is present, got to step 14. If voltage is not
present, repair/replace wire T of exhaust smoke generating system lead assembly (see WP 0246 00).
0092 00-9
