SECTION V: TROUBLESHOOTINGTM 9-2350-256-20WARNINGRemove all jewelry such as rings, dogtags, bracelets, etc. If jewelry contactsa metal surface a direct short may resultin instant heating of tools, damage toequipment, and injury or death topersonnel.N Reconnect wire C to APU GEN switch. Disconnect wireJ from APU GEN switch. Place red lead of multimeteron APU GEN switch terminal and black lead to ground.Turn MASTER and APU GEN switches ON, and checkfor voltage. Turn MASTER and APU GEN switchesOFF. If voltage is present, repair/replace wire J of APUcontrol box wiring harness (see paragraph 13-7). Ifvoltage is not present, replace APU GEN switch (seeparagraph 13-7). Reconnect wire J to APU GEN switch.Install rear panel (7), four lockwashers (6), and fourscrews (5) to APU control box (4). Disconnect APUcontrol box to foot dimmer switch and bulkhead wiringharness at APU control box.O Install APU control box (4), four screws (3), fourlockwashers (2), and four nuts (1). Reconnect APUcontrol box to foot dimmer switch and bulkhead wiringharness to APU control box. Disconnect bulkhead toengine wiring harness and starter relay wiring harnessfrom bulkhead disconnect. Place red lead of multimeteron pin F of wire J and black lead to ground. TurnMASTER and APU GEN switches ON and check forvoltage. Turn MASTER and APU GEN switches OFF.If voltage is present, go to step U. If voltage is notpresent, go to step P.2-153
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
