CHAPTER 6: MAINTENANCE OF ELECTRICAL SYSTEMS AND CIRCUITS
TM 9-2350-256-20
6-43 REPLACE ENGINE VOLTAGE REGULATOR TO ENGINE DISCONNECT WIRING HARNESS (DUAL
VOLTAGE} (11672415--Continued
a. REMOVAL
1 Remove two clamps (5) by removing screw (6)
and lockwasher (7) from each.
2 Disconnect connector (1) from engine disconnect
bracket (8).
3
Disconnect connector (2) from main engine
voltage regulator (9) by removing screw (10),
lockwasher (11), nut (12), and clamp (13).
4 Disconnect connectors (3 and 4) from bulkhead to
main engine bracket and rear fuel tank transmitter
wiring harness (14).
b. DISASSEMBLY
Disassemble wiring harness (see Chapter 6, Section
VII).
c. ASSEMBLY
Assemble wiring harness (see Chapter 6, Section VII).
d. INSTALLATION
1 Connect connectors (3 and 4) to bulkhead to main
engine bracket and rear fuel tank transmitter
wiring harness (10).
2 Connect connector (2) to main engine dual
voltage regulator (9).
3 Connect connector (1) to engine disconnect
bracket (8).
4 Install two clamps (5) using new lockwasher (7)
and screw (6) for each.
NOTE
Follow-on maintenance:
Install voltage
regulator access cover
(see paragraph 6-5)
Install engine deck (see
paragraph 9-51)
6-90
