CHAPTER 6: MAINTENANCE OF ELECTRICAL SYSTEMS AND CIRCUITS TM 9-2350-256-206-42 REPLACE/REPAIR BATTERIES TO MASTER RELAY, VOLTAGE REGULATOR, SLAVERECEPTACLE, AND ENGINE DISCONNECT WIRING HARNESS (SINGLE VOLTAGE) (11671791) --Continued7 Disconnect two connectors (9 and 10) frombattery (21) by pulling back rubber insulators (22)and removing bolt (23) and nut (24).b. DISASSEMBLYDisassemble wiring harness (see Chapter 6, SectionVII).c. ASSEMBLYAssemble wiring harness (see Chapter 6, Section VII).d. INSTALLATION1 Connect two connectors (9 and 10) to batteries(19) using bolt (23) and nut (24). Push rubberinsulators (22) back on battery terminal.2 Connect three connectors (6, 7, and 8) tobulkhead to main engine bracket and rear fueltank transmitter wiring harness (20).3Connect connector (5) to engine disconnect (19).4Connect two leads (3 and 4) to slave receptacle(16) using new lockwasher (18) and screw (17).5 Connect connector (2) to master relay (15).6-88
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
