SECTION V: VEHICLE WIRING
TM 9-2350-256-20
6
Connect connector (1) to voltage regulator (14).
7
Install eight clamps (11) using new lockwasher
(13) and screw (12) for each.
NOTE
Follow-on maintenance:
Install air inlet doors if
removed (see
paragraph 9-56)
6-43 REPLACE ENGINE VOLTAGE REGULATOR TO ENGINE DISCONNECT WIRING HARNESS (DUAL
VOLTAGE) (116724151
THIS TASK COVERS
a. Removal
b. Assembly
c. Disassembly
d. Installation
INITIAL SET-UP
Tools:
Equipment Conditions:
Tool kit, general mechanic's (Appendix C, item 53)
Engine deck removed (see paragraph 9-51)
Voltage regulator access cover removed (see
Parts:
paragraph 65)
Lockwashers (2) (Appendix G, item 116)
WARNING
Be certain MASTER switch is OFF when working on electrical systems to avoid electrical shock and
bums.
Connector No.
Electrical Lead To:
Wire No.
1
Engine disconnect
2
2
Main engine voltage regulator
2, 478, 1
3
Bulkhead to main engine bracket and rear fuel tank transmitter
1
wiring harness (dual voltage) (12322588)
4
Bulkhead to main engine bracket and rear fuel tank transmitter
478
wiring harness (dual voltage) (12322588)
6-89
