TM 9--2350--292--100102 00--3OPENING, REMOVAL, INSTALLATION AND CLOSING OF ARMOR SKIRTPANELS -- CONTINUED0102 00REMOVE ARMOR SKIRT PANELS FROM VEHICLENOTEThe removal procedure for all armor skirts are the same except for the location of theauxiliary boom.1. Open panels in accordance with this work package.2. Assemble auxiliary boom (WP 0039 00) and attach to D--ring (8) located inside each skirt panel.3. Using chain hoist, lift weight of the panel hinges (7) off of two stand--offs (5), remove two screws (4) from twostand--offs (5), and two hinge pins (6).4. Using a brass drift punch and hammer, remove two hinge pins (6).5. Pull skirt panel away from two stand--offs (5) and lower skirt panel to ground. Disconnect chain hoist.INSTALLATION OF ARMOR SKIRT PANELSWARNINGCAUTIONDo not drive vehicle unless skirts are secured in the closed position with hinge pins inplace. Failure to comply may result in panel swinging and causing damage.NOTEThe installation procedures for all armor skirts are the same except for the location ofthe auxiliary boom.1. Assemble auxiliary boom (WP 0039 00), and attach to D--ring (8) located inside each armor skirt panel.2. Using chain hoist, lift and position armor skirt panel onto two stand--offs (5) aligning mounting holes. Install twohinge pins (6) into two panel hinges (7) and two stand--offs (5).
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
