TM 9--2350--292--10
0103 00--1
TRACK TENSION ADJUSTMENT (OLD CONFIGURATION)
0103 00
THIS WORK PACKAGE COVERS:
Adjustment
INITIAL SETUP:
Tools and Special Tools
Wire brush
Grease gun adapter (item 2, Table 2, WP 0128 00)
Grease gun (item 17, Table 2, WP 0128 00)
Adjustable wrench (item 40, Table 2, WP 0128 00)
Spanner wrench (item 44, Table 2, WP 0128 00)
Screwdriver (item 30, Table 2, WP 0128 00)
Materials/Parts
Rags, wiping (item 45, WP 0130 00)
Grease (item 16, WP 0130 00)
Personnel Required
Three
References
WP 0130 00
WP 0102 00
WP 0019 00
WP 0128 00
WP 0108 00
1. Move vehicle back and forth two or three times over hard, level ground. Coast to a stop and stop engine (WP
0019 00).
2. Open armor skirt panels #1 through #7 (WP 0102 00).
3. Using wire brush, clean threads (1) on track adjusting link (2).
4. Using wiping rag (item 45, WP 0130 00), clean relief valve (3) and grease fitting (4).
5. Connect grease gun adapter (item 2, Table 2, WP 0128 00) (5) to grease fitting (4).
WARNING
Grease will be under pressure. Personnel must wear goggles. Failure to comply
may result in eye injury to personnel.
6. Using grease gun (item 17, Table 2, WP 0128 00), pump small amount of grease (item 16, WP 0130 00) into
adjusting link (2) to release locknut (6).
6
2
3
4
5
1
2
