TM 9--2350--292--20--1
0193 00--5
ENGINE REAR MOUNT AND BASE ASSEMBLY REPAIR -- CONTINUED
0193 00
Installation
1. Install shaft adapter bracket (46) and instruction plate (45) in vehicle hull with four screws (43) and four new lock-
washers (44).
2. Install bracket (40) on bulkhead with four screws (41) and four new lockwashers (42).
3. Install gear assembly (34) on bracket (40) with three screws (37), three new lockwashers (38) and three nuts (39).
4. Install machine key (36) and coupling shaft (16) on gear assembly (34). Tighten set screw (35) in coupling shaft
(16).
5. Install machine key (33) and coupling shaft (31) on gear assembly (34). Tighten set screw (32) in coupling shaft
(31).
6. Install universal joint (28) on coupling shaft (31) with straight headed pin (30) and new cotter pin (29).
Figure 3
29
30
28
31
32
33
34
35
16
36
37
38
39
40
41
42
43
43
44
44
45
46
