TM 9--2350--292--20--10219 00--2FUEL/WATER SEPARATOR AUTOMATIC DRAIN SYSTEM AND WIRINGHARNESS E2CA128--006 REPLACEMENT -- CONTINUED0219 00Removal1. Remove screw (1), lockwasher (2), flatwasher (3) and clamp (4) from fuel/water separator (5). Discard lockwasher.2. Loosen three screws (1) and disconnect upper and lower water sensor probes with leads (6) from two adapters (7).3. Disconnect two wiring harness connectors (8) from control module (9).4. Remove screws (10), lockwashers (11), flat washers (12) and clamps (13) securing two water sensor probe leads(6). Discard lockwasher.5. Remove four screws (14), four flat washers (15), wiring harness clamp (16) and control module (9) with water sen-sor probe leads (6) from mounting bracket (17).6. Disconnect wiring harness connector (8) from solenoid valve (18).7. Remove drain hose (19) and adapter (20) from solenoid valve (18).8. Remove drain tube (21) and elbow (22) from solenoid valve (18).9. Remove two assembled washer screws (23), two flat washers (24) and solenoid valve (18) from mountingbracket (17).10. Remove four screws (25), four lockwashers (26) and mounting bracket (17) from engine. Discard lockwashers.Figure 29888915161819202122231714176765124311121013242526
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
