TM 9--2350--292--20--1
0219 00--4
FUEL/WATER SEPARATOR AUTOMATIC DRAIN SYSTEM AND WIRING
HARNESS E2CA128--006 REPLACEMENT -- CONTINUED
0219 00
Installation--Continued
9. Install mounting bracket (17) on engine with four screws (25) and four new lockwashers (26).
10. Install solenoid valve (18) on mounting bracket (17) with two flat washers (24) and two assembled washer screws
(23).
11. Install elbow (22) in output side of solenoid valve (18), connect drain tube (21) to elbow (22).
12. Install adapter (20) in input side of solenoid valve (18), connect drain hose (19) to adapter (20).
13. Connect wiring harness connector (8) to solenoid valve (18).
14. Install control module (9) and wiring harness clamp (16) on mounting bracket (17) with four screws (14) and four
flat washers (15).
15. Connect two wiring harness connectors (8) to control module (9).
Figure 29
23
17
9
16
14
15
8
8
22
21
18
20
19
8
24
25
26
