ACCELERATOR CONTROLS AND LINKAGE REPAIR

RIGHT MANIFOLD HEATER ASSEMBLY AND RELATED PARTS REPLACEMENT - TM-9-2350-292-20-1_1163

Removal (cont) - TM-9-2350-292-20-1_1165

TM-9-2350-292-20-1 Carrier Ammunition Tracked M992A1(NSN 2360-01-362-3021) EIC:AE6 Manual
Page Navigation
1117

TM 9--2350--292--20--1 0226 00--1 ACCELERATOR CONTROLS AND LINKAGE REPAIR 0226 00 THIS WORK PACKAGE COVERS: Removal, Disassembly, Assembly, Installation INITIAL SETUP: Tools and Special Tools General mechanic’s tool kit (item 1, WP 0717 00) Retaining pliers set (item 15, WP 0717 00) Materials/Parts Lubricant (item 3, WP 0716 00) Dry--cleaning solvent (item 1, WP 0716 00) Adhesive (item 6, WP 0716 00) Self--locking nuts (3) (item 155, WP 0718 00) Lockwashers (7) (item 9, WP 0718 00) Retaining ring (item 131, WP 0718 00) Lockwashers (19) (item 2, WP 0718 00) Lockwashers (9) (item 12, WP 0718 00) Cotter pins (3) (item 19, WP 0718 00) Preformed packing (4) (item 20, WP 0718 00) Equipment Conditions Subfloor plates #19 and #24 removed (WP 0454 00) Engine deck grilles removed (TM 9--2350--292--10) Engine deck removed (WP 0417 00) Air cleaner intake hoses removed (WP 0212 00) Vehicular tool box rack and oddment tray assembly removed (WP 0480 00) References TM 9--2350--292--10 NOTE This task covers complete removal and installation of all accelerator controls and linkages. Perform only those steps necessary to replace the defective parts. Removal 1. Remove self--locking nut (1), screw (2) and rod assembly (3) from engine throttle lever (4). Discard self--locking nut. 2. Remove self--locking nut (5), screw (6) and rod assembly (3) from bell crank (7). Discard self--locking nut. 3. Remove two rod ends (8 and 9) and two nuts (10) from rod (11). Figure 35 1 4 8 2 10 10 11 9 5 3 7 6 FORWARD

Privacy Statement
Press Release
Contact