TM 9--2350--292--20--10226 00--6ACCELERATOR CONTROLS AND LINKAGE REPAIR -- CONTINUED0226 00Removal--Continued38. Remove screw (88) and lockwasher (89) from lever (90). Discard lockwasher.39. Remove screw (91) and lockwasher (92) from lever (90). Discard lockwasher.40. Remove lever (90) and woodruff key (93) from shaft (94).41. Remove rod assembly (95) from hull bracket (87).42. Remove rod end (96), clevis (70), two nuts (97 and 98), spring (99) and flat washer (100) from rod assembly (95).43. Remove screw (101), lockwasher (102) and lever (103) from rod (104). Discard lockwasher.44. Remove screw (105), lockwasher (106) and lever (107) from rod assembly (108). Discard lockwasher.45. Remove four screws (109), four lockwashers (110) and four flat washers (111) securing two pillow blocks (112)and shims (113 and 114). Discard lockwashers and locknuts.46. Remove shaft (94) with two pillow blocks (112), lever (107) and shims (113 and 114).Figure 341071081061051101119394871011021039870888990929196971009910495109110111109112114113114113112
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business