TM 9--2350--292--20--10226 00--7ACCELERATOR CONTROLS AND LINKAGE REPAIR -- CONTINUED0226 00Removal--Continued47. Remove screw (115), lockwasher (116), lever (107) and woodruff key (117) from shaft (94). Discard lockwasher.48. Loosen two set screws (118) in each of two pillow blocks (112).49. Remove shaft (94) from two pillow blocks (112).50. Remove two lubrication fittings (119) from two pillow blocks (112).51. Remove lubrication fitting (120) from pin (121).52. Remove cotter pin (122) from pin (121). Discard cotter pin.53. Remove pin (121) attaching pedal assembly (123) to floor bracket (124).54. Remove pedal assembly (123) with rod assembly (108) attached.55. Remove two cotter pins (125) from pin (126). Discard cotter pins.56. Remove two flat washers (127) and pin (126) and separate rod assembly (108) from pedal assembly (123).Figure 3494107108123124125127126127122121120115116118119117118118112119112
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business