TM 9--2350--292--20--1
LOW VOLTAGE STARTER PROTECTION MODULE REPLACEMENT
0241 00
THIS WORK PACKAGE COVERS:
Removal, Installation
INITIAL SETUP:
Tools and Special Tools
General mechanic’s tool kit (item 1, WP 0717 00)
Materials/Parts
Lockwashers (2) (item 85, WP 0718 00)
Marker tags (item 49, WP 0716 00)
Equipment Conditions
Vehicle MASTER switch OFF (TM 9--2350--292--10)
Powerpack removed (WP 0188 00)
References
TM 9--2350--292--10
Removal
NOTE
Tag all electrical connections and electrical leads prior to
removal to aid in installation.
1. Disconnect wiring harness 3W202 connector (1) from low voltage starter protection module (2).
2. Remove two nuts (3), two screws (4), two lockwashers (5) and low voltage starter protection module (2) from en-
gine mounting plate (6). Discard lockwashers.
3. Inspect parts for damage and replace as required.
Installation
1. Install low voltage starter protection module (2) on engine mounting plate (6) with two screws (4), two new lock-
washers (5) and two nuts (3).
2. Connect wiring harness 3W202 connector (1) to low voltage starter protection module (2).
Figure 47
1
2
3
6
5
4
NOTE
FOLLOW--ON MAINTENANCE:
Install powerpack (WP 0188 00)
END OF TASK
0241 00--1/2 blank
