TM 9--2350--292--20--1
ENGINE STARTER, CRADLE AND BRACKET REPLACEMENT -- CONTINUED
0240 00
Installation--Continued
6. Install two terminal lugs (19 and 20) for wires 14D and S on starter solenoid switch (S) terminal (21) with nut (17)
and lockwasher (18).
7. Install terminal lug (15) of wire T on starter solenoid motor (MTR) terminal (16) with nut (13) and lockwasher (14).
8. Install terminal lug (11) of wire 14B, three terminal lugs (10) for four no. 82 wires on starter solenoid battery (BAT)
terminal (12) with nut (8) and lockwasher (9).
9. Install terminal lug (5) for wire M, two ground straps (4) and terminal lug (3) for two GND wires on starter motor
ground terminal (6) with nut (1) and lockwasher (2).
CAUTION
Use only silicone adhesive listed in initial setup. Other
products could cause damage to equiipment.
10. Apply silicone adhesive to exposed terminals.
Figure 46
1
2
3
4
5
6
8
9
10
11
12
21
17
18
19
20
16
13
14
15
10
7
NOTE
FOLLOW--ON MAINTENANCE:
Install powerpack (WP 0188 00)
END OF TASK
0240 00--5/6 blank