TM 9--2350--292--20--10240 00--4ENGINE STARTER, CRADLE AND BRACKET REPLACEMENT -- CONTINUED0240 00Installation1. Install starter (27) with new mounting gasket (28) on adapter bolts (26) and place cradle (24) on angle bracket(34) on engine. Adjust cradle (24) until it sits flat on angle bracket (34) and screw holes in cradle (24) and anglebracket (34) align. Install three new self--locking nuts (25) on adapter bolts (26).2. Install angle bracket (34) on powerpack with four screws (32) and four flat washers (33).NOTEWhen attaching cradle to starter, tighten U--bolt justenough to hold cradle in position while starter is installed.Cradle position will be adjusted later.3. Position cradle (24) on new starter (27) in about same position as old starter (27), install U--bolt (31), with twoclamping bars (30) and two nuts (29). Feed starter solenoid wire (6) through cradle (24).WARNINGCAUTIONUse care in installing cradle to avoid damaging black so-lenoid to motor ground wire.4. Position suitable wooden blocks under starter assembly for support.5. Secure cradle (24) to angle bracket (34) with four flat washers (23) and four screws (22).Figure 46629302631243423223233282527
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
