TM 9--2350--292--20--1
0240 00--1
ENGINE STARTER, CRADLE AND BRACKET REPLACEMENT
0240 00
THIS WORK PACKAGE COVERS:
Removal, Installation
INITIAL SETUP:
Tools and Special Tools
General mechanic’s tool kit (item 1, WP 0717 00)
Materials/Parts
Self--locking nuts (3) (item 259, WP 0718 00)
Gasket (item 260, WP 0718 00)
Hardwood lumber (item 5, WP 0716 00)
Silicone adhesive (item 81, WP 0716 00)
Marker tags (item 49, WP 0716 00)
Equipment Conditions
Vehicle MASTER switch OFF (TM 9--2350--292--10)
Powerpack removed (WP 0188 00)
Personnel Required
Two
NOTE
Tag all electrical connections and electrical leads prior to
removal to aid in installation.
Large gauge black wire from starter solenoid to starter
motor ground terminal is part of starter assembly and
should not be removed.
Install nuts and lockwashers on starter terminals after
removal of wires. New starters are supplied with new
nuts and lockwashers.
Removal
1. Remove nut (1), lockwasher (2), terminal lug (3) for two GND wires, two ground straps (4) and terminal lug (5)
wire M from starter motor ground terminal (6). Do not remove terminal lug (7) of black wire connected from starter
solenoid.
2. Remove nut (8), lockwasher (9), three terminal lugs (10) for four no. 82 wires and terminal lug (11) of wire 14B
from starter solenoid battery (BAT) terminal (12).
3. Remove nut (13), lockwasher (14) and terminal lug (15) of wire T from starter solenoid motor (MTR) terminal (16)
(with buss bar to starter motor).
4. Remove nut (17), lockwasher (18) and two terminal lugs (19 and 20) for wires 14D and S from starter solenoid
switch (S) terminal (21).
