TM 9--2350--292--20--1
0291 00--1
WIRING HARNESS 2W601 REPLACEMENT (OLD CONFIGURATION)
0291 00
THIS WORK PACKAGE COVERS:
Removal, Installation
INITIAL SETUP:
Tools and Special Tools
General mechanic’s tool kit (item 1, WP 0717 00)
Materials/Parts
Lockwashers (21) (item 58, WP 0718 00)
Lockwashers (9) (item 9, WP 0718 00)
Grommet (item 348, WP 0718 00)
Lockwashers (2) (item 11, WP 0718 00)
Marker tags (item 49, WP 0716 00)
Equipment Conditions
Vehicle MASTER switch OFF (TM 9--2350--292--10)
Battery power disconnected (WP 0256 00)
Crew compartment subfloor plates #8, #9, #10, #11,
#13, #14, #15, #18, #22, #27 and #29 removed
(WP 0454 00)
References
TM 9--2350--292--10
Removal
NOTE
Tag all electrical connections and electrical leads prior to
removal to aid in installation.
The following legend identifies attachment points for each
connection.
Retain attaching hardware securing wires 359B to pay--
out and pay--in solenoid valves for installation.
1. Remove wiring harness (1) and attaching hardware, at the following attachment points:
Item
No.
2W601
Connector/Lead/Wire
From
Connector/Lead/Wire
Component
Location
2
Connector P3
Return Filter
Hydraulic Filter Manifold
(Below Subfloor Plates--Near
Hydraulic Reservoir)
3
Connector P4
Charge Filter
Hydraulic Filter Manifold
(Below Subfloor Plates--Near
Hydraulic Reservoir)
4
Connector P5
Hydraulic Reservoir Oil Tem-
perature Switch
Hydraulic Reservoir
(Below Subfloor Plates)
5
Wire 664
Hydraulic Reservoir Oil Tem-
perature Sensor
Hydraulic Reservoir)
(Below Subfloor Plates)
6
Connector P6
Hydraulic Reservoir Liquid Lev-
el Sensor
Hydraulic Reservoir)
(Below Subfloor Plates)
7
Terminal GND
Hydraulic Reservoir Liquid Lev-
el Sensor Ground
Hydraulic Reservoir)
(Below Subfloor Plates)
