SLOW OR NO HYDRAULIC COMPONENT OPERATION WITH HYDRAULIC SELECTOR SET IN MAIN POSITION (cont)

SLOW OR NO HYDRAULIC COMPONENT OPERATION WITH HYDRAULIC SELECTOR SET IN MAIN POSITION (cont) - TM-9-2350-292-20-1_417

SLOW OR NO HYDRAULIC COMPONENT OPERATION WITH HYDRAULIC SELECTOR SET IN MAIN POSITION (cont) - TM-9-2350-292-20-1_419

TM-9-2350-292-20-1 Carrier Ammunition Tracked M992A1(NSN 2360-01-362-3021) EIC:AE6 Manual
Page Navigation
374

TM 9--2350--292--20--1 0089 00--12 SLOW OR NO HYDRAULIC COMPONENT OPERATION WITH HYDRAULIC SELECTOR SET IN MAIN POSITION -- CONTINUED 0089 00 W Is pressure 440--625 psi? CONTINUED FROM STEP V no yes CONTINUED ON NEXT PAGE 1. Start main engine, energize hydraulics, and set engine speed to 1800 rpm (TM 9--2350--292--10). Record pressure at MS port of filter valve manifold. 2. Shut down hydraulics and main engine (TM 9--2350--292--10). X Are both pressures 4100--4300 psi? no yes 1. Disconnect quick--disconnects at main winch. 2. Remove hose and adapter from hoist and main winch directional control valve port LS1. Remove plug from port LS and install plug in port LS1 and install hose and adapter from LS1 into port LS. 3. Start main engine, energize hydraulics, and set engine speed to 1800 rpm (TM 9--2350--292--10). 4. Place main winch control lever in either inhaul or payout position and record pressures at ports MS and X1 of hydraulic front pump. 5. Shut down hydraulics and main engine (TM 9--2350--292--10). Fault corrected. Notify Direct Support Maintenance. FORWARD

Privacy Statement
Press Release
Contact