SLOW OR NO HYDRAULIC COMPONENT OPERATION WITH HYDRAULIC SELECTOR SET IN AUXILIARY POSITION (cont)

SLOW OR NO HYDRAULIC COMPONENT OPERATION WITH HYDRAULIC SELECTOR SET IN AUXILIARY POSITION (cont) - TM-9-2350-292-20-1_421

SLOW OR NO HYDRAULIC COMPONENT OPERATION WITH HYDRAULIC SELECTOR SET IN AUXILIARY POSITION (cont) - TM-9-2350-292-20-1_423

TM-9-2350-292-20-1 Carrier Ammunition Tracked M992A1(NSN 2360-01-362-3021) EIC:AE6 Manual
Page Navigation
378

TM 9--2350--292--20--1 0090 00--3 SLOW OR NO HYDRAULIC COMPONENT OPERATION WITH HYDRAULIC SELECTOR SET IN AUXILIARY POSITION -- CONTINUED 0090 00 CONTINUED FROM STEP E CONTINUED ON NEXT PAGE Is reading on gauge 1650--1750 psi? no yes 1. Remove hydraulic control valve manifold assembly shields (WP 0519 00). 2. Install a 4000 psi testing gauge assembly in the APU TEST port on the hydraulic control valve manifold assembly. 3. Start the APU (TM 9--2350--292--10). 4. Place the system selector in the AUX position. 5. Place all other control handles in the center (neutral) position. Read gauge. 6. Shut down the APU (TM 9--2350--292--10). Go to Step I. Is reading on gauge 1650--1750 psi? no yes 1. Shift system selector to the fuel transfer position. 2. Start the APU (TM 9--2350--292--10) and read gauge. 3. Shut down the APU (TM 9--2350--292--10). Fault corrected. If an auxiliary component fails to operate, go to Quick Guide and find appro- priate troubleshooting. FORWARD F Is vehicle equipped with Enhanced Diagnostic System? G H no yes Go to Step K. WARNING

Privacy Statement
Press Release
Contact