TM 9--2350--292--20--1
0134 00--2
TRANSMISSION OIL PRESSURE GAUGE FAILS TO OPERATE -- CONTINUED
0134 00
C
Is 24 V dc present?
CONTINUED FROM STEP A
no
yes
1. Remove switch panel from bracket and
reconnect ground strap to switch panel
(WP 0242 00).
2. Disconnect lead 10 from CB6.
3. Turn MASTER switch ON
(TM 9--2350--292--10).
4. Place red multimeter lead in lead 10 socket
connector and black lead to ground. Check for
voltage.
5. Turn MASTER switch OFF
(TM 9--2350--292--10).
Go to WP 0131 00 and troubleshoot
wiring harness 4W105 P1 lead 10 from
switch panel. Verify fault is corrected.
Is 24 V dc present?
no
yes
1. Disconnect harness 3W202 lead 321 from
transmission oil pressure transmitter.
2. Turn MASTER switch ON
(TM 9--2350--292--10).
3. Place multimeter red lead in lead 321
transmitter connector socket and black lead
to ground. Check for voltage.
4. Turn MASTER switch OFF
(TM 9--2350--292--10).
Replace transmitter (WP 0349 00).
Verify fault is corrected.
CONTINUED FROM STEP B
CONTINUED ON NEXT PAGE
Is 24 V dc present?
1. Disconnect lead 25/27 from CB6.
2. Place one multimeter lead on each CB6
connector pin. Check for continuity.
3. Reconnect leads 10 and 25/27 to CB6.
D
E
no
yes
Replace CB6 (WP 0242 00). Verify
fault is corrected.