PERSONNEL HEATER FAILS TO KEEP BURNING

PERSONNEL HEATER FAILS TO IGNITE (HEATER BLOWER OPERATES PROPERLY) (cont) - TM-9-2350-292-20-1_690

POWER TAKEOFF ELECTRICAL SYSTEM OVERVIEW AND DIAGRAMS

TM-9-2350-292-20-1 Carrier Ammunition Tracked M992A1(NSN 2360-01-362-3021) EIC:AE6 Manual
Page Navigation
647

TM 9--2350--292--20--1 PERSONNEL HEATER FAILS TO KEEP BURNING. 0142 00 THIS WORK PACKAGE COVERS: Personnel Heater Fails To Keep Burning INITIAL SETUP: Tools and Special Tools General mechanic’s tool kit (item 1, WP 0000 00) Equipment Conditions Vehicle MASTER switch OFF (TM 9--2350--292--10) Air particulate filter and bracket removed (WP 0000 00) Personnel Required Two Did fuel flow from fuel line in a steady flow? 1. Loosen (but do not remove) fuel line from personnel heater. 2. Hold a shop rag around fuel line fitting and place HEATER CONTROL switch to START position (TM 9--2350--292--10). 3. Bleed air from fuel line until steady flow of fuel runs from fuel line. 4. Place HEATER CONTROL switch to OFF position (TM 9--2350--292--10). WARNING Remove rings, bracelets, wristwatches, and neck chains before working on any vehicle. Jewelry can catch on equip- ment and cause injury, or may short across an electrical circuit and cause severe burns or electrical shock. yes no Go to WP 0141 00 Step B. Tighten fuel line. Verify fault is corrected. END OF TASK 0142 00--1/2 blank

Privacy Statement
Press Release
Contact