TM 9--2350--292--20--1
0144 00--1
PTO CLUTCH DOES NOT ENGAGE, INDICATOR IS NOT LIT AND
GOVERNOR DOES NOT OPERATE PROPERLY.
0144 00
THIS WORK PACKAGE COVERS:
PTO Clutch Does Not Engage, Indicator Is Not Lit And Governor Does Not Operate Properly
INITIAL SETUP:
Tools and Special Tools
General mechanic’s tool kit (item 1, WP 0717 00)
Multimeter (item 84, WP 0717 00)
Equipment Conditions
Vehicle MASTER switch OFF (TM 9--2350--292--10)
Personnel Required
Two
Is 24 V dc present?
1. Disconnect harness 2W601 P1 from accessory
control panel receptacle J1.
2. Turn MASTER switch ON
(TM 9--2350--292--10).
3. Place multimeter red lead in harness 2W601
P1 socket V and black lead to ground. Check
for voltage.
4. Turn MASTER switch OFF
(TM 9--2350--292--10).
no
yes
no
yes
A
B
CONTINUED ON NEXT PAGE
1. Open accessory control panel (WP 0244 00).
2. Disconnect lead 10 from CB4 terminal 1 in
accessory control panel.
3. Place one multimeter lead on lead 10 CB4
connector pin and other lead on accessory
control panel receptacle J1 pin V. Check for
continuity.
Is continuity present?
WARNING
Remove rings, bracelets, wristwatches,
and neck chains before working on any
vehicle. Jewelry can catch on equip-
ment and cause injury, or may short
across an electrical circuit and cause
severe burns or electrical shock.
Repair (WP 0290 00) or replace
(WP 0291 00) harness 2W601.
Verify fault is corrected.
Repair (WP 0290 00) or
replace (WP 0244 00)
lead 10. Verify fault is
corrected.
