TM 9--2350--292--20--1
0144 00--4
PTO CLUTCH DOES NOT ENGAGE, INDICATOR IS NOT LIT AND
GOVERNOR DOES NOT OPERATE PROPERLY -- CONTINUED
0144 00
CONTINUED FROM STEP F
CONTINUED ON NEXT PAGE
Did indicator light?
no
yes
1. Turn PTO CLUTCH switch OFF
(TM 9--2350--292--10).
2. Reconnect lead 524/627 to switch S6 and
reconnect leads 627 and lead 524 to switch S6.
3. Reconnect harness 2W601 P1 to control panel
receptacle J1.
4. Remove subfloor plates 26 and 27
(WP 0454 00).
5. Disconnect harness 2W601 from PTO
CLUTCH.
6. Turn PTO CLUTCH switch and MASTER
switch ON (TM 9--2350--292--10) and watch
ENGAGED indicator.
7. Turn PTO CLUTCH switch and MASTER
switch OFF (TM 9--2350--292--10).
Go to Step K.
G
H
Is 24 V dc present?
no
yes
1. Disconnect lead 524 from diode T10 terminal
D.
2. Turn MASTER switch ON
(TM 9--2350--292--10).
3. Place multimeter red lead on lead 524 diode
connector and black lead to ground. Check for
voltage.
4. Turn MASTER switch OFF
(TM 9--2350--292--10).
Repair (WP 0290 00) or re-
place (WP 0244 00) lead 524.
Verify fault is corrected.
