TM 9--2350--292--20--1
0183 00--1
MAIN WINCH FAILS TO SHUT DOWN WHEN WINCH TEST SWITCH IS HELD
IN TEST POSITION.
0183 00
THIS WORK PACKAGE COVERS:
Main Winch Fails To Shut Down When Winch Test Switch Is Held In Test Position
INITIAL SETUP:
Tools and Special Tools
General mechanic’s tool kit (item 1, WP 0717 00)
Multimeter (item 84, WP 0717 00)
Equipment Conditions
Vehicle MASTER switch OFF (TM 9--2350--292--10)
Hydraulic system operating (TM 9--2350--292--10)
Personnel Required
Two
Is either the LEVEL WINDER MALFUNCTION, WINCH
DRUM MALFUNCTION, or PAYOUT LIMIT indicators
lit?
Check winch indicators on hydraulic control panel.
no
yes
A
B
CONTINUED ON NEXT PAGE
Hold WINCH TEST switch in the TEST position
and watch SYSTEM WARNING indicator on
gauge panel.
Does indicator light?
WARNING
Remove rings, bracelets, wristwatches,
and neck chains before working on any
vehicle. Jewelry can catch on equip-
ment and cause injury, or may short
across an electrical circuit and cause
severe burns or electrical shock.
Go to Step H.
no
yes
C
1. Shut down hydraulics system, main engine
and MASTER switch (TM 9--2350--292--10).
2. Disconnect harness 4W618 P2 from harness
4W617 J1.
3. Turn MASTER switch ON
(TM 9--2350--292--10).
4. Place multimeter red lead in harness 4W618
P2 pin H and black lead to ground. Check for
voltage.
5. Turn MASTER switch OFF
(TM 9--2350--292--10).
Is 24 V dc present?
Go to Step P
