MAIN WINCH FAILS TO SHUT DOWN WHEN WINCH TEST SWITCH IS HELD IN TEST POSITION (cont)

MAIN WINCH FAILS TO SHUT DOWN WHEN WINCH TEST SWITCH IS HELD IN TEST POSITION (cont) - TM-9-2350-292-20-1_809

MAIN WINCH FAILS TO SHUT DOWN WHEN WINCH TEST SWITCH IS HELD IN TEST POSITION (cont) - TM-9-2350-292-20-1_811

TM-9-2350-292-20-1 Carrier Ammunition Tracked M992A1(NSN 2360-01-362-3021) EIC:AE6 Manual
Page Navigation
766

TM 9--2350--292--20--1 0183 00--4 MAIN WINCH FAILS TO SHUT DOWN WHEN WINCH TEST SWITCH IS HELD IN TEST POSITION -- CONTINUED 0183 00 CONTINUED FROM STEP A CONTINUED ON NEXT PAGE H Is continuity present? no yes 1. Shut down hydraulics system, main engine and turn MASTER switch OFF (TM 9--2350--292--10). 2. Remove hydraulic control panel (WP 0245 00). 3. Remove clamp securing harness 4W618 (WP 0331 00). 4. Disconnect harness 4W617 lead 359 from WINCH TEST and WINCH OVERRIDE switches. 5. Place one multimeter lead in harness 4W617 lead 359 connector socket to WINCH TEST switch and other lead on harness 4W617 lead 359 connector to WINCH OVERRIDE switch. Check for continuity. Repair (WP 0290 00) or replace (WP 0330 00) harness 4W617. Verify fault is corrected. I Is continuity prersent? CONTINUED FROM STEP G no yes 1. Disconnect harness 4W617 lead 359B from WINCH OVERRIDE switch. 2. Place one multimeter lead on each WINCH OVERRIDE switch connector terminal. 3. Place WINCH OVERRIDE switch in the OFF position and check for continuity. Replace WINCH OVERRIDE switch (WP 0245 00). Verify fault is corrected.

Privacy Statement
Press Release
Contact