MAIN WINCH FAILS TO SHUT DOWN WHEN WINCH TEST SWITCH IS HELD IN TEST POSITION (cont)

MAIN WINCH FAILS TO SHUT DOWN WHEN WINCH TEST SWITCH IS HELD IN TEST POSITION (cont) - TM-9-2350-292-20-1_813

MAIN WINCH FAILS TO SHUT DOWN WHEN WINCH TEST SWITCH IS HELD IN TEST POSITION (cont) - TM-9-2350-292-20-1_815

TM-9-2350-292-20-1 Carrier Ammunition Tracked M992A1(NSN 2360-01-362-3021) EIC:AE6 Manual
Page Navigation
770

TM 9--2350--292--20--1 0183 00--8 MAIN WINCH FAILS TO SHUT DOWN WHEN WINCH TEST SWITCH IS HELD IN TEST POSITION -- CONTINUED 0183 00 Is continuity present? CONTINUED FROM STEP B no yes 1. Shut down hydraulics system, main engine and turn MASTER switch OFF (TM 9--2350--292--10). 2. Disconnect harness 2W601 P1 from accessory control panel. 3. Remove subfloor plate 18 (WP 0454 00). 4. Disconnect harness 2W601 P1 lead 359B from main winch payin safety valve. 5. Place one mulitmeter lead in harness 2W601 P1 socket L and other lead on harness lead 359B main winch payin safety valve connector socket. Check for continuity. Repair (WP 0290 00) or replace (WP 0291 00) harness 2W601. Verify fault is corrected. CONTINUED ON NEXT PAGE Is vehicle equipped with main winch power reduction manifold? no yes Go to WP 0185 00. P Q

Privacy Statement
Press Release
Contact