MAIN WINCH POWER IS NOT REDUCED WHEN OVERRIDE SWITCH IS IN OVERRIDE POSITION

MAIN WINCH DOES NOT OPERATE WITH THE OVERRIDE SWITCH HELD IN THE OVERRIDE POSITION (cont)

MAIN WINCH POWER IS NOT REDUCED WHEN OVERRIDE SWITCH IS IN OVERRIDE POSITION (cont) - TM-9-2350-292-20-1_819

TM-9-2350-292-20-1 Carrier Ammunition Tracked M992A1(NSN 2360-01-362-3021) EIC:AE6 Manual
Page Navigation
774

TM 9--2350--292--20--1 0185 00--1 MAIN WINCH POWER IS NOT REDUCED WHEN OVERRIDE SWITCH IS IN OVERRIDE POSITION. 0185 00 THIS WORK PACKAGE COVERS: Main Winch Power Is Not Reduced When Override Switch Is In Override Position INITIAL SETUP: Tools and Special Tools General mechanic’s tool kit (item 1, WP 0717 00) Multimeter (item 84, WP 0717 00) Jumper wires Equipment Conditions Vehicle engine shut down (TM 9--2350--292--10) Personnel Required Two Are all wiring harness connectors properly connected? 1. Remove subfloor plate 18 (WP 0454 00). 2. Inspect all electrical connections to main winch power reduction manifold (WP 0292 01). no yes A B CONTINUED ON NEXT PAGE 1. Remove hydraulic control panel (WP 0245 00). 2. Remove wiring harness 2W612 lead 359B from override switch (WP 0292 00). 3. Place one multimeter lead on terminal 2 of override switch and other lead on terminal 3 of override switch. 4. Move WINCH OVERRIDE switch to OVERRIDE and hold (TM 9--2350--292--10). Check for continuity. 5. Release override switch (TM 9--2350--292--10). Is continuity present? WARNING Remove rings, bracelets, wristwatches, and neck chains before working on any vehicle. Jewelry can catch on equip- ment and cause injury, or may short across an electrical circuit and cause severe burns or electrical shock. Tighten electrical connector to main winch power reduction manifold (WP 0292 01). Verify fault is corrected. no yes Replace winch override switch (WP 0335 00). Verify fault is corrected.

Privacy Statement
Press Release
Contact