TM 9--2350--292--20--20363 00--2BRAKE ROD ASSEMBLY 12366874 REPAIR (OLD CONFIGURATION) --CONTINUED0363 00AssemblyNOTEA minimum of 0.62 inch (15.7 mm) must be maintainedbetween face of nuts and end of rod assembly.1. Install nut (13) on stud (12).2. Install stud (12) with nut (13) on rod (14). Do not tighten nut (13).3. Install nut (10) and rod end clevis (11) on stud (12). Do not tighten nut (10).4. Install nut (8) and rod end bearing (9) on rod assembly (3). Do not tighten nut (8).InstallationWARNINGAdjustment to length of rod assemblies must be accom-plished by adjusting both rod end clevises evenly. Rodend clevises must maintain a minimum of 0.62 inch (15.7mm) thread engagement from end of rod assemblies atall times. Failure to comply could result in rod assemblyseparation causing loss of vehicle service brake, resultingin personnel injury or equipment damage.1. Adjust rod end bearing (9), rod end clevis (11) and stud (12) on rod assembly (3) until two headed straight pins (2and 6) can be freely installed in brake pedal and bracket assembly (4) and lever (7).2. Install two headed straight pins (2 and 6) and two new cotter pins (1 and 5).3. Tighten three nuts (8, 10 and 13).4. Perform brake linkage alignment (WP 0355 00 or WP 0356 00).5. Adjust brake locking rod (WP 0358 00).Figure 16814567112981210314130.62 IN(15.7 MM)0.62 IN(15.7 MM)0.62 IN(15.7 MM)NOTEFOLLOW--ON MAINTENANCE:Install accelerator linkage as required (WP 0226 00)Install subfloor plates #6 and #13 (WP 0454 00)END OF TASK
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
