TM 9--2350--292--20--2
0706 00--2
M2A2 GAS PARTICULATE FILTER UNIT (GPFU), HOSE ASSEMBLIES,
FRAME ASSEMBLIES, BRACKETS, LEAD ASSEMBLY 4W303 AND
ASSOCIATED HARDWARE REPLACEMENT -- CONTINUED
0706 00
Removal
1. Disconnect wiring harness 4W307 connector P2 (1) from connector J1 (2) at M2A2 gas particulate filter unit (3).
2. Remove screw (4), lockwasher (5) and lead assembly 4W303 (6) from M2A2 gas particulate filter unit (3). Dis-
card lockwasher.
3. Remove three hoses (7), three orifice connectors (8) and three wire rope assemblies (9) from manifold of M2A2
gas particulate filter unit (3) and three clamps (10).
4. Remove three wire rope assemblies (9) and three orifice connectors (8) from three hoses (7).
NOTE
Do not remove wire rope assemblies from hose orifice
connectors unless wire rope assemblies or orifice con-
nectors are damaged.
5. Remove three wire rope assemblies (9) from three orifice connectors (8), if damaged.
6. Remove three screws (11), three lockwashers (12), three clamps (10) and three wire rope assemblies (9) from
bracket on vehicle wall. Discard lockwashers.
7. Remove hose assembly (13) from M2A2 gas particulate filter unit (3).
Figure 373
1
10
12
11
8
9
7
8
9
2
3
5
4
6
FORWARD
7
13