TM 9--2350--292--20--2
0387 00--2
SUSPENSION HUB ASSEMBLY REPAIR -- CONTINUED
0387 00
Disassembly
1. Remove eight screws (14), eight lockwashers (15), seal assembly (16) and gasket (17) from hub assembly (6).
Discard lockwashers and gasket.
2. Remove inner bearing (18) from suspension arm assembly (10) spindle.
3. Remove relief valve (19) and bushing (20) from access cover (3).
4. Remove lubrication fitting (21) and bushing (22) from hub assembly (6).
5. Remove plug (23) from hub assembly (6).
NOTE
Bearing cones and bearing cups are used in matched
sets only. If either is damaged, cone and cup must be
replaced as a set.
6. Remove inner bearing cup (24) from hub assembly (6), if damaged.
7. Remove outer bearing cup (25) from hub assembly (6), if damaged.
NOTE
There are 10 screws in suspension hub assembly. Re-
move only those screws that are damaged.
8. Remove screws (26) from hub assembly (6).
Figure 179
25
24
14
15
16
17
18
26
23
6
21
22
3
20
19
