TM 9--2350--292--20--2
0387 00--4
SUSPENSION HUB ASSEMBLY REPAIR -- CONTINUED
0387 00
Assembly -- Continued
NOTE
Once the seal assembly is unbolted from the hub during
maintenance, the alignment is lost and must be re--estab-
lished. Perform steps 9 through 17 to re--establish align-
ment.
9. Position four screws (14) with four new lockwashers (15) equally spaced around seal assembly (16).
10. Install new preformed packing (13) on suspension arm assemblly (10) spindle spacer.
11. Install seal assembly (16) over spacer on suspension arm assembly (10) spindle and flush against mating surface
on suspension arm assembly (10).
12. Install inner bearing (18) on suspension arm assembly (10) spindle. Make sure that bearing (18) is seated against
spacer on suspension arm assembly (10) spindle.
Figure 179
14
15
16
18
10
13