TM 9--2350--292--20--2
0388 00--3
SUSPENSION ARM ASSEMBLY REPAIR -- CONTINUED
0388 00
Assembly
1. Apply a light coating of lubricant to all components prior to assembly.
2. Install new seal (12) in retainer (11) with spring loaded lip facing inside of retainer (11).
3. Install retainer (11) with new seal (12) on suspension arm assembly (3).
4. Install sleeve bearing (10) and spacer (9) on suspension arm assembly (3).
5. Install sleeve bearing (8) on suspension arm assembly (3).
6. Install flat washer (7) and new key washer (5) on suspension arm assembly (3).
7. Install bearing nut (6). Torque bearing nut (6) to minimum of 150 lb--ft (203 NSm).
8. Loosen bearing nut (6) until bearing assembly can rotate by hand one full revolution. Torque nut (6) to 15--20 lb--ft
(20--27 NSm).
9. Bend tang on new key washer (5) to lock bearing nut (6) in place.
Figure 179
12
11
10
9
8
7
5
6
3
