SUBFLOOR REPLACEMENT - TM-9-2350-292-20-2

TM-9-2350-292-20-2 Recovery Vehicle Heavy Full-Tracked: M88A2 (NSN 2350-01-390-4683) (EIC:ACQ) Manual
Page Navigation
452

TM 9--2350--292--20--2 0454 00--1 SUBFLOOR REPLACEMENT 0454 00 THIS WORK PACKAGE COVERS: Removal, Installation INITIAL SETUP: Tools and Special Tools General mechanic’s tool kit (item 1, WP 0717 00) Materials/Parts Adhesive (item 28, WP 0716 00) Lockwashers (8) (item 12, WP 0718 00) Nonmetallic seal (item 134, WP 0718 00) Lockwashers (8) (item 78, WP 0718 00) Lockwashers (21) (item 2, WP 0718 00) Lockwashers (4) (item 135, WP 0718 00) Nonmetallic grommet (item 136, WP 0718 00) Lockwashers (2) (item 356, WP 0718 00) Assembled--washer screws (3) (item 421, WP 0718 00) Assembled--washer screws (90) (item 424, WP 0718 00) Lockwashers (9) (item 11, WP 0718 00) Assembled--washer screws (22) (item 444, WP 0718 00) Assembled--washer screws (3) (item 445, WP 0718 00) Equipment Conditions Commander’s seat removed (WP 0457 00) For replacement of plate #21 Hoist winch wire rope shield removed (WP 0495 00) For replacement of plate #14 Brake bleed valve manifold and hoses removed (WP 0361 00 or WP 0362 00) For replacement of plate #14 Air cleaner assemblies removed (WP 0208 00) For replacement of plates #24 or #32 Throttle pedal and linkage removed (WP 0226 00) Shift linkage removed (WP 0350 00) Brake linkage removed (WP 0363 00 or WP 0364 00), (WP 0365 00), (WP 0366 00 or WP 0367 00) and (WP 0368 00) Dimmer switch removed (WP 0260 00, WP 0261 00) For replacement of plate #7 Basket supports removed (WP 0465 00) For replacement of supports Personnel required Two NOTE The subfloor plates are bolted to plate supports attached to the hull inner structure. The plates have been num- bered in the illustration and legend to aid in removal and installation of plates. Certain plates have hinged doors for quick access to the under floor compartments. Lift doors to open. Perform only those steps necessary to replace defective parts. Perform Removal and Installation of plate #11 for access to main winch oil fill/drain plug, oil level check, hydraulic hose quick--disconnect, cable access plate, boom shutoff valve and the auxiliary winch relief valve. Perform Removal and Installation of plate #13 for access to the hoist winch fill and level check. Perform Removal and Installation of plate #15 for access to the hoist winch drain. Perform Removal and Installation of plate #28 for access to the hydraulic oil tank fill and oil level indicator. Perform Removal and Installation of plate #20 for access to the fuel level sending unit and fuel pump.

Privacy Statement
Press Release
Contact