HOIST BOOM PULLEYS REPLACEMENT

TM-9-2350-292-20-2 Recovery Vehicle Heavy Full-Tracked: M88A2 (NSN 2350-01-390-4683) (EIC:ACQ) Manual
Page Navigation
648

TM 9--2350--292--20--2 0524 00--1 HOIST BOOM PULLEYS REPLACEMENT 0524 00 THIS WORK PACKAGE COVERS: Removal, Installation INITIAL SETUP: Tools and Special Tools General mechanic’s tool kit (item 1, WP 0717 00) Socket wrench socket (item 101, WP 0717 00) Socket wrench set (item 89, WP 0717 00) Adjustable automotive wrench (item 92, WP 0717 00) Materials/Parts Cotter pin (item 124, WP 0718 00) Self--locking nut (item 125, WP 0718 00) Equipment Conditions Boom derigged (TM 9--2350--292--10) References TM 9--2350--292--10 Personnel Required Two Removal 1. Remove cotter pin (1), nut (2), flat washer (3) and stayline cable (4) from shaft (5). Discard cotter pin. WARNING 2. Remove self--locking nut (6), nut (7), flat washer (3) and stayline cable (8) from shaft (5). Discard self--locking nut. 3. Remove shaft (5), three spacers (9) and two pulleys (10) from boom. 4. Remove lubrication fitting (11) from shaft (5). 5. Inspect parts for damage and replace as required. Figure 282 1 2 3 4 5 7 8 11 6 9 10 9 10 9 3

Privacy Statement
Press Release
Contact