TM 9--2350--292--20--2MAIN HYDRAULIC PUMPS’ ASSEMBLY AND POWER TAKEOFF (PTO)CLUTCH REPLACEMENT -- CONTINUED0545 00Installation--ContinuedWARNING9. Position lifting slings to cradle main hydraulic pumps’ assembly and PTO clutch assembly (1), attach lifting slingsto lifting device. Raise lifting device to remove slack from lifting slings.10. Using suitable lifting device and lifting slings, install main hydraulic pumps’ assembly and PTO clutch (1) in ve-hicle.11. Align main hydraulic pumps’ assembly mount (6) and PTO clutch assembly (7) to support plate (8), install eightscrews (2), eight new lockwashers (3), two flat washers (4) and shim(s) (5). Shim as required to maintain align-ment between the main hydraulic pumps’ assembly (12) and PTO clutch (7).Figure 2921223378612455NOTEFOLLOW--ON MAINTENANCE:Connect wiring harness 2W601 wire 627 to PTO clutchassembly and wire 525 to PTO clutch assembly hightemperature switch (WP 0291 00 or WP 0291 01)Connect fuel lines from bulkhead to fuel tank(WP 0217 00)Connect PTO shaft to PTO clutch assembly(WP 0544 00Install hydraulic lines and fittings on main hydraulicpumps (WP 0565 00)Install rear subfloor stowage basket support(WP 0465 00)Install floor support (WP 0454 00)Install commander’s cupola mounting plate(WP 0444 00)END OF TASK0545 00--5/6 blank
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
