TM 9--2350--292--20--2
0545 00--3
MAIN HYDRAULIC PUMPS’ ASSEMBLY AND POWER TAKEOFF (PTO)
CLUTCH REPLACEMENT -- CONTINUED
0545 00
Removal--Continued
WARNING
CAUTION
Place wooden blocks to ensure main hydraulic pumps’
assembly is level when separated from PTO clutch as-
sembly and hydraulic pumps’ assembly mount is remove-
Failure to comply could result in equipment damage.
3. Using suitable lifting device, remove main hydraulic pumps’ assembly and PTO clutch (1) from vehicle. Place
hydraulic pumps’ assembly and PTO clutch (1) on wooden blocks. Remove lifting slings and lifting device.
4. Remove four screws (9), four lockwashers (10) and four flat washers (11). Discard lockwashers.
5. Separate main hydraulic pumps’ assembly (12) from PTO clutch assembly (7) to disengage hydraulic pumps’ as-
sembly splined shaft (13).
NOTE
Two studs, two nuts and two flat washers securing mount
to hydraulic pump assembly must be reinstalled in pump
after mount has been removed from hydraulic pumps’
assembly.
6. Remove two studs (14), two nuts (15) and two flat washers (16) and hydraulic pumps’ assembly mount (6) from
hydraulic pumps’ assembly (12).
7. Remove high temperature switch (17) from adapter (18).
8. Remove adapter (18) from PTO clutch assembly (7).
9. Inspect parts for damage and replace as required.
1
6
12
9
10
11
7
13
14
16
15
18
17
