TM 1-1680-320-13&P
0013 00
INTERVAL
ITEM
ITEM TO BE
PROCEDURES
NO.
INSPECTED
D
M
Q
A
*
Inspect and clean full length of cable using a clean, low-
lint cloth. With a gloved hand, hold cloth firmly around
cable to aid in removal of foreign particles and detection
of broken wires. Simultaneously check cable for bird
caging, kinks, abrasions, and flat spots.
12
Boomhead Assembly
Inspect boomhead assembly for nicks, cracks,
*
scratches, and dents. Inspect for corrosion. (Refer to
Inspect cable cutter and switch harness assembly for
cuts, tears, fraying, and broken insulation. Inspect
identification and lubrication plates for legibility and
security of attachment. Check boom head for freedom of
movement. Check boom head fluid level.
Drain and service boom head assembly in accordance
*
Visually inspect for nicks, cracks, and corrosion. Ensure
13
*
Cable Cutter
electrical connecter is secured and check for frayed or
broken insulation.
Visually inspect electrical connector for bent, broken,
*
Connect a 28 volt dc light or multimeter cable connector
at boomhead. Operate CABLE CUT switch at operator
and pilot position. Verify positive indication.
Visually inspect for nicks, cracks, corrosion, and
14
*
Winch Assembly
evidence of leakage. Inspect identification and
attachment. Inspect electrical wiring for frayed or broken
insulation. Inspect mounting hardware for security.
*
NOTE
Mission and/or environmental conditions will
mandate accelerated or advanced cleaning
Remove drum cover and drum assembly and visually
inspect inner lining wear patterns in accordance with
WP 0024 00 inspection criteria. Visually inspect cable
kicker for cracks, dents, or nicks. Inspect level wind
Drain and service winch assembly in accordance with
0013 00-3