TM 9-2350-238-10OPERATING CRANE–CONTINUEDREEVING BOOM WINCH WIREROPE–CONTINUED2345Operate boom winch control handle (1)and pay out about 3 ft (0.92 m) of wirerope. Refer to page 2-73. Release singleboom block (2) from front of vehicle.Place block on transmission deck.Support winch wire rope clevis (3) andremove quick release pin (4) securingclevis to boom and remove clevis (3) andwire rope. Install quick release pin inboom,Remove two quick release pins (5) fromsingle boom block (2). Pull wire rope (6)and clevis through block. Install quickrelease pins (5) in single boom block (2),Stow boom block in cab stowagecompartment.After single line pull operation, reevewire rope through single boom block andattach wire rope clevis to boom usingreverse of steps 1 thru 4 above.TRAVERSING CAB1 Start hydraulic system, Refer to page2-67Make sure all personnel stand clear of boomand block before traversing cab.2 Operate boom winch. Refer to page2-73. Pay out about 1 ft (0.30 m) ofwire rope and release single boom block(1) from front of vehicle.3 Raise boom until block clears front deck.2-78
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business