TM 9-2350-238-10
EMERGENCY OPERATION OF CRANE
AND SPADE–CONTINUED
RAISING SPADE–CONTINUED
2
3
4
5
6
7
8
9
10
Route impact wrench hose (1) as shown,
Traverse cab counterclockwise
to working position to prevent
damage to hose. From working
position traverse cab clockwise
only to prevent damage to
hose.
Connect impact wrench hose (1) to large
quick disconnect coupling (3) at right
front of hand pump.
Drive vehicle off spade.
NOTE
Pull from spade if vehicle is
disabled.
Pull impact wrench pressure selector
valve (4) out.
Turn spade control valve handle in
driver’s compartment to RAISE.
Operate hydraulic ram hand pump (5) for
approximately 2 minutes to raise spade.
Install spade travel lock and tighten
securely.
Push pressure selector valve (4) in.
Remove, drain, and stow impact wrench
hose (1).
Return cab to travel position.
CAB IN TRAVEL POSITION
CAB IN WORKING POSITION
2-91
