TM 9-2350-256-20-2
UNIT MAINTENANCE
RECOVERY VEHICLE, FULL TRACKED: MEDIUM, M88A1
NSN 2350-00-122-6826, EIC AQA
ACCELERATOR CONTROLS AND LINKAGES ALIGNMENT
ALIGNMENT, ADJUSTMENT
INITIAL SETUP:
Tools and Special Tools
Equipment Condition
Tool kit, general mechanic's (item 59, WP 0490 00)
Powerplant removed for alignment only (see WP 0098
Punches, drive (2) (locating pins) (item 43, WP 0490 00)
00)
Engine throttle lever linkage disconnected (see WP 0363
Materials/Parts
Adhesive, rubber-base (item 3, WP 0489 00)
Alignment
1.
Loosen nuts (1 and 2).
2.
Insert 1/8-in.- (3.2 mm-) diameter locating pin (3) in bracket (4) and accelerator pedal (5) (point 1).
3.
Adjust linkage leaving nuts (1 and 2) loose until 1/8-in.- (3.2 mm-) diameter locating pin (6) can be inserted in bell crank
(7) (point 2).
4.
Tighten nuts (1 and 2). Remove locating pins (3 and 6) and connect linkage to engine throttle lever (see WP 0363 00).
0364 00-1
