TM 9-2350-256-20-2
0364 00
Adjustment
NOTE
Step 1 refers of full throttle adjustment.
1.
Loosen nut (1) (point 1) and adjust throttle stop (8) as required to obtain full throttle acceleration. Tighten nut.
NOTE
Steps 2 and 3 refer to hand throttle adjustment.
2.
Loosen two nuts (9) (point 3) on throttle control cable (10) at accelerator connecting lever (11). Push in throttle control
handle (12) all the way.
3.
Adjust two nuts (9) until 3/16-in. (4.8-mm) movement of throttle control handle (12) causes increase in engine speed with
engine operating at idle.
NOTE
Step 4 refers to rubber boot final adjustment.
4.
With throttle control handle (12) adjusted and accelerator pedal (5) released, extend rubber boot (13) to 2-5/8 in. (66.7 mm)
(as shown in illustration). Cement rubber boot to bulkhead with adhesive and clamp to rod (14) with clamp (15) (see WP
0364 00-2
