TM 9-2350-256-20-2
UNIT MAINTENANCE
RECOVERY VEHICLE, FULL TRACKED: MEDIUM, M88A1
NSN 2350-00-122-6826, EIC AQA
CREW FAN AND BOOM BOOT DRAIN SHUTOFF CLAMP INSTALLATION
INITIAL SETUP:
Tools and Special Tools
Materials/Parts (cont.)
Tool kit, general mechanic's (item 59, WP 0490 00)
Tape, adhesive (item 7, WP 0465 00)
Lockwashers (4) (item 642, WP 0491 00)
Materials/Parts
Nuts (4) (item 769, WP 0491 00)
Compound, caulking (item 3, WP 0465 00)
Screws (4) (item 401, WP 0491 00)
NOTE
Items removed for installation of kit and not reused should be stowed for reinstallation when kit parts
are removed.
Installation
1.
Tape crew fan switch, located on accessories panel, to OFF position with adhesive tape (item 7, WP 0465 00).
2.
Remove ventilating blower assembly (1) by removing three screws (2), three lockwashers (3), and three nuts (4).
3.
Apply caulking compound (item 3, WP 0465 00) to seal assembly (5) and place seal assembly into opening of crew fan
housing (6). Tighten seal assembly screws until watertight fit is obtained.
4.
Install ventilating blower assembly (1) with three screws (2), three lockwashers (3), and three nuts (4).
5.
Install kit-furnished clamp (7) on crew fan housing (6) drain hose.
6.
Install one kit-furnished clamp (8) on right and left drain hoses of boom cylinder boot (9).
END OF WORK PACKAGE
0472 00-1/2 blank
