SECTION V: CONROLS AND LINKAGES
TM 9-2350-256-20
4
Tighten all nuts and remove locating pins.
Adjustment
1
With brake not applied and each brake-apply lever against its stop, measure 3 in. (76.2 mm) back on each rod from
brake adjustment indicator and place mark 1/2-in. (12.7-mm) wide on rod so centerline of mark is 3 in. (76.2 mm)
from centerline of indicator (point 2).
2
Apply brake fully and note position of mark with respect to indicator; mark and indicator should aline. If not, proceed
to step 3 and adjust.
3
With brake fully applied, place 9/16-in. socket wrench on brake-apply lever adjustment bolt. While pushing in with
wrench to release bolt, turn bolt (clockwise if mark is in front of indicator, counterclockwise if mark is behind) until
mark on rod alines with indicator.
9-197
