CHAPTER 11: MAINTENANCE OF MAIN WINCH, HOIST
TM 9-2350-256-20
WINCH, AND RELATED COMPONENTS
11-6 REPLACE HOIST WINCH HOSE AND CABLE ASSEMBLY-Continued
4
Run cable slowly out and guide cable off drum (7).
5
Remove ferrule filler (8) by depressing filler spring (9).
6
Remove cable assembly (10) from dummy filler (11) by disengaging rope ferrule (12).
7
Remove dummy filler (11) from drum (7).
b.
INSTALLATION
1
Install dummy filler (11) in drum (7).
2
Install cable assembly (10) to dummy filler (11) by
engaging rope ferrule (12).
3
Coat ferrule filler (8) with GAA grease and install
with filler spring (9) in between rope ferrule (12)
and dummy filler (11).
4
Install tee (5) and seal (6).
5
Install hoses (1 and 4) on tee (5).
6
Install hose (1) onto elbow (2), and install two band
markers (3) to hose.
7
Run winch slowly and guide cable on drum (7).
NOTE
Follow-on maintenance:
Close cab subfloor plates as required (see paragraph 9-2
through 9-23)
11-7 SERVICE HOIST WINCH BRAKE BAND ADJUSTMENT
THIS TASK COVERS
Adjustment
INITIAL SET-UP
Tools:
Equipment Condition:
Tool kit, general mechanic's (Appendix C, item 53)
U-35 winch center right floor plate opened (see
paragraph 9-4)
11-10
