SECTION Ill: WIRE ROPE SHIELD AND ROLLER ASSEMBLY
TM 9-2350-256-20
NOTE
Follow-on maintenance:
•Install water can brackets (see paragraph 9-106)
•Install commander’s seat (see paragraph 9-65)
•Install forward floor plate (see paragraph 9-19)
•Install dome light (see paragraph 6-34)
• Install accessories panel (see paragraph 6-9)
11-10 REPLACE/REPAIR WIRE ROPE ROLLER HOUSING AND BEARING
ASSEMBLY
THIS TASK COVERS
a. Removal
b. Disassembly
INITIAL SET-UP
Tools:
Tool kit, general mechanic’s (Appendix C, item 53)
c. Assembly
d. Installation
Reference:
Deleted
Parts:
Lockwashers (8) (Appendix G, item 132)
Equipment Condition:
Hoist winch cable access door opened (see
paragraph 9-4)
a. REMOVAL
Remove two housing and bearing assemblies (1) and
two rollers (2) by removing eight screws (3) and eight
lockwashers (4).
b. DISASSEMBLY
Remove four fittings (5) and four sleeve bearings (6).
c. ASSEMBLY
Install four sleeve bearings (6) and four fittings (5).
d. INSTALLATION
1
Install eight new lockwashers (4), eight screws (3),
and two rollers (2) into two housing and bearing
assemblies (1).
2
Lubricate housing and bearing assemblies (1) using
four fittings (5) (see Appendix J).
NOTE
Follow-on maintenance:
Close hoist winch
cable access door (see
paragraph 9-4)
Change 1
11-15
