SECTION III: WIRE ROPE SHIELD AND ROLLER ASSEMBLY
TM 9-2350-256-20
SECTION III: WIRE ROPE SHIELD AND ROLLER ASSEMBLY
Para.
Task
Page
11-9
Replace Wire Rope Shield ...................................................................................................................... 11-13
11-10
Replace/Repair Wire Rope Roller Housing and Bearing Assembly .......................................................... 11-15
11-9 REPLACE WIRE ROPE SHIELD
THIS TASK COVERS
a. Removal
b. Installation
INITIAL SET-UP
Tools:
Equipment Conditions:
Tool kit, general mechanic's (Appendix C, item 53)
Accessories panel removed (see paragraph 6-9)
Dome light removed (see paragraph 6-34)
Center forward floor plate removed (see
paragraph 9-19)
Parts
Lockwashers (43) (Appendix G, item 118)
Commander's seat removed (see paragraph 9-65)
Water can brackets removed (see paragraph
9-106)
a. REMOVAL
1
Remove five screws (1) and five lockwashers (2) from each side at top of shield assembly (3).
2
Remove nine screws (4) and nine lockwashers (5) from bottom of shield assembly (3).
3
Remove shield assembly (3) by hand by turning on its side and removing through personnel door.
11-13
