CHAPTER 12: MAINTENANCE OF MAIN HYDRAUUC SYSTEMTM 9-2350-256-2012-10 REPLACE/REPAIR OIL TEMPERATURE TRANSMITTER AND SWITCHHOUSING ASSEMBLY-Continueda. REMOVALDisconnect harness assembly (1), and remove housingassembly (2) and gasket (3) by removing six screws (4)and six lockwashers (5). Discard gasket.b. DISASSEMBLY1 Remove four screws (6) and four lockwashers (7).2 Unscrew cap (8) and remove from cover (9).3 Disconnect harness assembly (10), connector (wirenumber 664) from transmitter (11), and connector(wire number 663) from switch (12).4 Unscrew and remove transmitter (11) and switch(12) from cap (8).5 Remove harness assembly (10) and gasket (13)from cover (9). Discard gasket.c. ASSEMBLY1 Place harness assembly (10) and new gasket (13) incover (9).2 Install transmitter (11) and switch (12) on cap (8).3 Connect harness assembly (10), connector (wirenumber 664) to transmitter (11), and connector(wire number 663) to switch (12).4 Screw cap (8) on cover (9).5 Secure harness assembly (10) and new gasket (13)to cover (9) with four screws (6) and four newlockwashers (7).d. INSTALLATIONInstall harness assembly (1), housing assembly (2), and new gasket (3) to tank with six screws (4) and six newlockwashers (5).NOTEFollow-on maintenance:Install rear intermediate right access floor plate (see paragraph 9-10)12-11 REPLACE MECHANICAL TRANSMISSION ID PLATETHIS TASK COVERSa. Removalb. InstallationINITIAL SET-UPTools:Parts:Tool kit, general mechanic's (Appendix C, item 53)Drivescrews (4) (Appendix G, item 18)12-38
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business