TM 9-2350-256-20
APPENDIX I: DEEP WATER FORDING KIT
TABLE I-1. MISCELLANEOUS ITEMS-Continued
Item
Document/
National Stock
Number
Part Number
Number
3
11672186
8030-01-031-9155
4
MIL-A-46106
8040-01-010-8758
5
MIL-A-46146
8040-01-063-7509
6
ASTM D 3400
6810-00-247-0607
7
PPP-T-60
-
-
8
MIL-I-24391
5970-00-419-4290
9
DDD-R-30
7920-00-205-1711
10
GGG-W-665
5120-00-293-1602
I
I - 1 C L E A N I N G
Description
Caulking compound-1-1/2-inch-(in.-) (38-
millimeter) wide x 25-foot- (ft-) (7.62-meter-
[m-] ) long roll
Sealant, adhesive, RTV, general purpose,
white-l-ounce (28.4-gram) primer and 10.3-
ounce (292-gram) adhesive
Sealing compound, RTV general
noncorrosive-l-gallon (3.79-liter) pail
Sodium silicate, type 2-5-gallon (3.79-liter)
pail
Tape, adhesive, type I, class I, olive drab num-
ber 34087-2-m- (51-millimeter-) wide x 60-
yard- (54.9-m-) long roll
Tape, insulation, electrical, black-0.50-in.-
(12.7-millimeter-) wide x 0.010-in- (0.25-
millimeter-) thick roll
Wiping rags, cotton, grade B-50 pounds (22.7
kilograms)
Wrench, spanner, universal hose coupling,
type V
Clean and dry vehicle thoroughly. Surfaces to be covered with nonhygroscopic tape or sealer must be clean and
dry.
l - 2 I N S P E C T I O N
1
Perform semiannual Preventive Maintenance Checks and Services (PMCS) (see paragraph 2-10).
2
Inspect drain valves for proper operation and fit. Repair or replace if necessary.
3
Inspect rubber boots used to seal service brake, steer-and-shift, and accelerator rods at side of bulkhead on
sponson.
Notify Direct Support Maintenance to replace boots that are defective or do not provide a
watertight fit.
4
Inspect rubber drain boots on boom for proper seal. Replace if necessary.
5
Inspect main engine and Auxiliary Power Unit (APU) oil filler caps, main engine and APU oil level gages,
and transmission filler cap/oil level gage to ensure watertight fits. Replace if necessary.
l-2
Change 1
