APPENDIX I: DEEP WATER FORDING KITTM 9-2350-256-201-6 ENGINE GENERATOR COOLING EXHAUST--Continuedd. Install clevis (14) and nut (15) onto end of control cable (4). Tighten nut.e. Attach clevis (14) to valve assembly (1) with pin (16) and new cotter pin (17).9Position air exhaust elbow (18) on shroud connection in an inverted position (pointing up) and secure withhose clamp (19).10 Operate hand lever by exerting sufficient pull on T-handle (20) and valve assembly (1), and lock in placeby rotating T-handle clockwise.11 Fill air exhaust elbow (18) with water and allow to sit for 5 minutes. If valve assembly (1) is seated properlyand no leakage is detected, reposition valve assembly by loosening two screws (2). Then, tighten screwsand recheck for watertight seal.12 Reposition air exhaust elbow (18) on exhaust air tubes (21) and shroud connection and secure with twohose clamps (22).I-6
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
